Photon Focus MV3-D640I-M01-144-CL, User Manual, Page: 32 / 121

4 Image Acquisition
4.6.3 Trigger Mode
The trigger mode defines, if the trigger is active. Following settings are available:
• On
• Off
4.6.4 Trigger Activation
The trigger activation defines, which edge of the selected trigger is processed in the trigger
signal path. Following configuration is available:
• Rising Edge
• Falling Edge
• Both Edges
The trigger Activation configuration is only available, when the trigger source is
set to Line In.
4.6.5 Trigger Divider
The trigger divider specifies a division factor of the incoming trigger pulses. A division factor of
1 process every incoming trigger. A division factor of 2 process every second trigger and so on.
4.6.6 Trigger Delay
The trigger delay let the user specifies a delay, that will be applied between the reception of a
trigger event and when the trigger becomes active.
4.7 Software Signal Pulse and User Output
The software signal pulse block contains eight general purpose registers which allow
generating internal pulse signals by software access. These pulse signals are internally
connected to following functions, where it can be used to start a procedure:
• Acquisition Start Trigger
• Acquisition End Trigger
• Frame Start Trigger
• Frame Burst Start Trigger
• Frame Burst End Trigger
• Exposure Start Trigger
• Exposure End Trigger
• Counter Trigger
• Counter Event
• Counter Reset
• Timer Trigger
32 of 121 MAN076 09/2017 V1.0