Loosen the two side bolts and the central one on
the print platform. From the front screen press
‘Maintain’ and then ‘Home z-axis’ button on the
front panel to lower the platform. Note that the
platform will not move until the hood is placed
on the printer. Align the glass platform to fit the
screen and tighten the central bolt. Wearing
gloves press down hard in the middle of the
glass and then tighten both side bolts on the
platform one after the other. Press ‘+10’, and the
platform will lift 10mm, pour the amount of resin
you need into the vat, then press ‘-10’ to return it
to the screen and you are homed!
2. THE HOMING
PROCEDURE
NOTE:
If you have an object that is 100 cm3 then it will use
115g of resin. Always overfill by at least 20% to ensu-
re consistent resin flow. For most prints, filling the vat
to 1/3 full is more than enough. Place the hood back
on the printer.
NOTE:
You can check the screen is working by pressing the
“Show calibration” button located in the “Maintain” tab
and a red grid will appear.
NOTE:
Don’t remove the hood during the operation or the print
will stop.
7
8
