Phonic XP6000, User Manual

Page: 8 / 20

4
XP6000
English
PARALLEL / STEREO / BRIDGE MONO
Turn the power off before changing the operation mode as to
avoid damaging your XP6000. The number 4 and 5 DIP switches
allow users to change between stereo and parallel input modes,
whereas DIP switches 7 and 8 are used to activate bridge mono
mode. DIP switches 6 and 9 are used to activate the Parallel and
Bridge Mono Indicators, respectively.
Stereo Mode: each channel of the amplifier
runs independently with its own signal and
speakers. To set the amplifier to Stereo mode,
set DIP switches 4, 5, 7 and 8 to the left
position. DIP switches 6 and 9 should be set
to the left hand position so as to ensure the
Parallel and Bridge Mono indicators are off.
The loading of each speaker in Stereo mode
should be 2 ohms or above.
Parallel Mode: this allows the input of channel
1 to feed channel 2 also. This allows channel
1 and 2 outputs to drive their own speakers
independently, however with the same source.
To set Parallel mode, DIP switches 4 and 5
should be set to the right, however switches 7
and 8 should be position to the left. You can
also activate the Parallel indicator by setting
DIP switch 6 to the right and DIP switch 9 to
the left. The loading of each speaker in Parallel mode should be
2 ohms or above.
Bridge Mono: the signal
of both inputs is combined
and fed through the bridge
mono output at twice the
regular power. The channel
2 gain should be set to a
minimum, and a rated load
must be used for the higher output power. To set Bridge Mono
mode, DIP switches 4, 5, 7, 8 and 9 should all be set to the right,
and switches 6, 10 and 11 should be set to the left. You can also
activate the Bridge Mono LED by setting DIP switch 9 to the right
and DIP switch 6 to the left. The loading of the speaker in Bridge
Mono mode should be 4 ohms or above.