Phoenix MicroATX Express, Installation Manual

Page: 18 / 72

Phoenix MicroATX Express – Installation Guide
6.
7.
8.
9.
Actuate fasteners
Both fastener
halves are flush
against spring
Fastener flush
against spring
•
While holding HS to prevent tilting, press down on
fastener caps with thumb to install and lock
Repeat with remaining fasteners
Inspection
•
Verify the fasteners are properly seated
•
Ensure both fastener cap and base are flush with spring
and motherboard
Connect fan header with Board header
Secure excess cable with tie-wrap to ensure cable does not
interfere with fan operation or contact other components.
This completes the installation of the CPU. Now is it a good time to double check both the CPU and the DIMM
installation to make sure that these devices have been properly installed.
Installing Cables
Power and Control Panel Cables
The Phoenix MicroATX Express gets power from the ATX connector J32 ( Figure 1-2 ) and ATX 12V J24 ( Figure
1-2 ).
Power Connector (24-pin block): ATXPWR24P(J32)
ATX Power Supply connector. This is a newly defined 24-pin connector that usually comes with an ATX
case. The ATX Power Supply allows using soft power on momentary switch that connect from the front panel
switch to 2-pins Power On jumper pole on the motherboard. When the power switch on the back of the ATX power
supply is turned on, the full power will not come into the system board until the front panel switch is momentarily
pressed. Press this switch again will turn off the power to the system board.
** We recommend that you use an ATX 12V Specification 2.0-compliant power supply unit (PSU) with a
minimum of 350W power rating. This type has 24-pin and 4-pin power plugs.
10
StockCheck.com
Downloaded from StockCheck.com