- 24 -
o
Navigate to the [Auto Upgrade Settings]
menu
o
You will see below items:
o
[Auto Upgrade and Clone]: RF upgrade
and Clone upgrade will be enabled
automatically at 4 AM / 1 PM if the TV
is in standby and 5 minutes after the TV
is put in STBY if [On] is selected, no
upgrade will happen if [Off] is selected
o
[Auto Clone on Wakeup]: Nothing will
happen when [Off] but when [On] the
TV shall search for a new clone when
waking up from standby. You will see a
message
“Personalizing
your
experience” when starting up the TV
Note:
TVSettings,
ChannelList,
SmartInfoBrowser, MyChoice data will
be cloned on wakeup. Depending on SW
updates and feature updates this list
might change overtime
o
Navigate to the [RF Upgrade Settings]
menu
o
You will see below items:
o
[Frequency]: The frequency for CMND
playout can be modified in this menu
Note: Default this should be set to 498
MHz. When an RF upgrade happens, the
TV will first do a scan on the frequency
set here. If nothing is found it will scan
between 44 MHz and 887 MHz in steps
of 8MHz. So if you do a playout on
another frequency as set in the TV, the
TV will do a fallback scan in order to find
it
o
[Scan Mode]:Define when the TV shall
scan the RF stream for updates
When [Legacy] is selected, then the
RF scan for upgrades will happen 5
minutes after the TV is set to STBY,
1PM and at 4AM when the TV is not
in use.
When [Continuous] is selected, the
TV will scan continuously when the
TV is in standby and also when in on
state
Note: in order to set the [Scan
Mode], the TV must be in [Fast]
mode. In Green mode, the TV
will always follow the [Legacy] scanning
