Philips DVDR3575H/, Service Manual

Page: 63 / 195

Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12 Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006
Philips Semiconductors Page 43 of 124
1
Nucleus Name DS_BE_FocusOn
Nucleus Number 913
Description Put the laser of the bit-engine into focus by issuing a TRANSPARENT SEND
and TRANSPARENT_RECEIVE command. This nucleus is not guaranteed to
work on all connected BEs
Technical - Send the transparent BIT engine FOCUS command
Important note: This nucleus uses the transparent bit engine interface of the drive. It is
not guaranteed to work on all drives. Only use this nucleus if you are sure
that the drive supports this interface
Execution Time 3 seconds
User Input None
Error Number Description
91300 Focus on succeeded
91301 There was a time-out while communicating
91302 The Basic Engine returned an unexpected result
91303 The BE returned an error code
91304 No acknowledge received from BE
91305 Communicating with the Basic Engine failed
91306 Unable to enter service mode
Example DS:> 913
091300:
Test OK @
2
Nucleus Name DS_BE_FocusOff
Nucleus Number 914
Description Turn off putting the laser of the bit-engine into focus by issuing a
TRANSPARENT SEND and TRANSPARENT_RECEIVE command. This
nucleus is not guaranteed to work on all connected BEs
Technical
-
Send the transparent BIT engine FOCUS command
Important note: This nucleus uses the transparent bit engine interface of the drive. It is
not guaranteed to work on all drives. Only use this nucleus if you are sure
that the drive supports this interface
Execution Time 2 seconds
User Input None
Error Number Description
91400 Focus off succeeded
91401 There was a time-out while communicating
91402 The Basic Engine returned an unexpected result
91403 The BE returned an error code
91404 No acknowledge received from BE
91405 Communicating with the Basic Engine failed
91406 Unable to enter service mode
Example DS:> 914
091400:
Test OK @
3
Nucleus Name DS_BE_MotorOn
Nucleus Number 915
Description Turn on the turntable motor by issuing a TRANSPARENT SEND and
TRANSPARENT_RECEIVE command. This nucleus is not guaranteed to work
on all connected Bes
Technical - Send the transparent BIT engine TTM command
Important note: This nucleus uses the transparent bit engine interface of the drive. It is
not guaranteed to work on all drives. Only use this nucleus if you are sure
that the drive supports this interface
Execution Time 4 seconds
User Input None
Error Number Description
91500 Turn table motor is on
91501 There was a time-out while communicating
91502 The Basic Engine returned an unexpected result
91503 The BE returned an error code
91504 No acknowledge received from BE