Philips 91816 Light Palette Classic 1500, Installation & Setup Manual

Page: 79 / 96

Selecting Channels and Setting Levels
71
Light Palette Lighting Control Console
Installation & Setup Guide
2. Using the Keypad to Select Channels
To Select Channels Using Keypad:
Step 1. At keypad, enter number of channel(s) you wish to select. (Typing will be reflected in the Command Line.)
Step 2. Use + (And), / (Through) and - (Minus) keys to select groups of channels.
Step 3. Press [@] or [*] on the QWERTY keyboard to set a level in percent.
Step 4. Enter percentage value. If you enter a single number, it will be multiplied by 10 (example: pressing [5]
[ENTER] results in 50%).
Step 5. Press [ENTER] to complete the action.
Level Entry Mode
When working on the command line you can choose to terminate fixture selection and level set commands with or
without using the [ENTER] key. The options are to use Enter, Single Digit or Two Digit entry. With single digit entry
the syntax [1] [THRU] [1] [0] [@] [5] will take 1 through 10 to 50%. To achieve the same thing with Two Digit entry,
you would type [1] [THRU] [1] [0] [@] [5] [0]. If you wanted 5% in single digit entry, type [1] [THRU] [1] [0] [@]
[0] [5] [ENTER].
Note : Typing [1] [THRU] [1] [0] [@] [.] [1] [2] [7] [ENTER] will set fixtures 1 through 10 to 50%
in any mode. The decimal point identifies setting DMX512 values.
Notes:
• Alternately, you can select channels and roll the wheel to increase or decrease their level from the current position.
• Holding down [SHIFT] while rolling the wheel, changes the values in Decimal rather than Percent.
• To set a level of 5%, enter [0] [5] [ENTER].
• Use the [@] [LOOK] syntax to open the Apply Levels dialogue box to reference pre-recorded Looks as Light Pal-
ette references.
• Make sure the Num Lock key is on before using the numeric keypad.
Note: For more detailed instructions, refer to "Command Line Syntax" in the PaletteOS software Help Menu .
3. Using the Mouse to Select Channels
Note: For more detailed instructions, refer to "Using the Mouse to Select Channels and Levels" in the PaletteOS
software Help Menu .
To Select channels Using Mouse:
Step 1. Position mouse pointer on channel number and left-click. Red outline will appear.
Step 2. Select multiple channels with mouse by left-clicking on first channel, holding left button down, and
dragging mouse to last channel in group.
Step 3. Use mouse wheel to change level of selected channels.