Battery/Tank Monitor BTM2
REV 1A - FEB 2022 - Software Version 1.xPage 8
Remove the cover
Break out the metal tongue with flat-nose pliers
Inserting the rubber cable grommet Inserting the cover and the cable.
Inserting the interface board ACE-LIN
Make sure that the ACE charger is disconnected from the
AC mains before starting work.
After removing the front cover, the setting of the DIP switches must be adjusted for operation with
the CAE-LIN interface.
The ACE chargers are equipped with DIP switches to adjust the charging
characteristic individually to the batteries. Only if the DIP switches of the
charger are set to ABCD = "1111", the charging characteristic can be adjusted
from the monitor BLS. Then it is also possible to set a user-defined
characteristic curve. Otherwise, the characteristic curve set via the DIP switches
applies.
For the electrical connection of the interface board, the 16-pin connector of the ribbon cable must
be plugged into the matching red connector on the main board of the charger ACE.
