Battery/Tank Monitor BTM2
REV 1A - FEB 2022 - Software Version 1.xPage 2
1 General information
1.1 V purpose of use
The battery/tank monitor BTM can only be operated in conjunction with the shunt SHE-348 on
extra-low voltage DC 8-32V. It is designed for use on yachts and may only be operated in enclosed
spaces protected from rain, moisture, dust and condensation. Never use the battery/tank monitor
in locations where there is a risk of explosion from gas or dust. The battery/tank monitor is not
suitable for outdoor installation.
1.2 L Scope of delivery
- Battery/Tank Monitor BTM2
- 3 Plug-in terminals
(2x MVSTB 2.5- 3 and 1x 9-pole)
- 2 fuse holder ASH1 with fuse FSS 1A
- These operating instructions
Optional accessories (not included in the scope of delivery):
SHUNT SHE 348 for battery capacity detectionOrder no.: 0 7003 0348
SHUNT SHP 348 for solar power measurement
Order no.: 0 7003 0351
Temperature sensor Temp-BT
Order no.: 0 5900 3480
Battery charger interface ACE-LIN
Order no.: 0 8000 4975
N2K cable for NMEA 2000 connection
Order no.: 5 0411 1140
1.3 RECOMMENDED FUEL SENSORS (not included)
To measure the fill level, we recommend the immersion tube sensor of the TGT or TGW series for
fuel and fresh water as well as the ultrasonic sensor UTV for faeces tanks and the flow rate sensor
DFS (fresh water only). For deep tanks up to 200 cm and a very precise measurement, the pressure
sensor TDS200 (water/diesel/faeces) or TDW200 (water/faeces).
However, these sensors are not included in the scope of delivery.
Sensors from other manufacturers can also be connected. The display is configured to the
connected sensors in SETUP. Furthermore, an adjustment to the tank geometry is possible in order
to correctly display the actual tank content.
Please note: only with the DFS
flow sensors is the litre display accurate, as litres are also measured here. With all
other sensors, this is only a conversion of the measured fill level and, depending on the
sensor accuracy, can never be accurate to the litre!
Fresh water:
-Flow sensor (1x)
DFS
Order no.: 7 0003 0304
-immersion tube sensor
TGW 200-800
Order no.: 6 6011 7xxx
-Pressure sensor
TDN 200 / TDT 250
Order no.: 6 6025 1208
Petrol:
