Battery/Tank Monitor BTM2
REV 1A - FEB 2022 - Software Version 1.xPage 17
4.6 SETTINGS IN THE TANK MENU:
The respective tank menu for
the tanks shown is accessed
by pressing the button
(arrow on the right):
In the tank menu, the volume, the tank type, the sensor type can be entered and an adjustment to
the tank geometry can be made.
With the free setting of the resistance range (User R), the ohm values for 0%, 25%, 50%, 75% and
100% are entered in this menu or the tank monitor can adopt the resistance values for these fill
levels at the push of a button.
The same applies to tank sensor with a voltage output (sensor type: User U).
For the sensor type UTV 40/80, the tank depth is entered in this menu.
These settings are saved in the event of a power failure and are available again when the unit is
switched back on.
4.6.1 TANK TYPE E
There are 5 different tank symbols to choose from for each tank:
Water / Diesel / Petrol / Faecal matter (black water) / Grey water
4.6.2 VOLUME
Enter the tank volume. The content is displayed in litres.
4.6.3 SENSOR
Sensor typeTank sensorMeasuring range
Geometry adjustment
TGX 10-180 (Ohm)
philippi TGT / TGW
10.. 180 Ohm
optional240
- 33 (Ohm)
240...33 Ohm
UTR not possible!
optional
User R
1 - 1000 Ohm
1 - 1000 Ohm
necessary
User V (0-10V)
philippi UTV (0,5-2,5V)
0.. 10V
necessary
UTV 40/80
philippi UTV 40/UTV 80
0,5.. 2,5 Voptional
TDx
TDS / TDN / TDT
(4 - 20mA)
necessary
DFS
-
(down)
philippi DFSFlow sensor not
possibleDFS
+
(up)
philippi DFS flow sensor not possible
TRS / RSW / DSW
philippi TRS / RSW / DSWFloat switch
not possible
