Philco PD 1251 BiT, User Manual

Page: 35 / 116

EN - 33
10/2012 Copyright © 2012, Fast ČR, a. s.
Error codes
Error code Description Possible causes
P1 P2 P3 P4 P5
Insuffi cient water
supply
Check that the water inlet is fully open
and that the water supply was not
interrupted.
Shut off the water inlet. Unscrew
the water supply hose and clean out
the fi lter on the end of the hose.
Restart the dishwasher, contact an
authorised service centre.
Water supply
failure
Shut off the water inlet.
Contact an authorised service centre.
It is not possible
to pump residual
water out of the
dishwasher.
The drain hose is clogged.
The fi lters may be clogged.
Turn off the dishwasher and turn
on the cancel wash programs.
If the problem persists contact an
authorised service centre.
Heat malfunction Contact an authorised service centre.
The warning
indicator light is
activated when
the dishwasher
overfl ows.
Turn off the dishwasher and close
the water inlet.
Contact an authorised service centre.
Faulty electronic
card
Contact an authorised service centre.
Overheating
malfunction (the
temperature of the
dishwasher is too
high)
Contact an authorised service centre.
Heat sensor error Contact an authorised service centre.
WARNING!

In the event that the dishwasher becomes fl ooded, close the water supply before calling the
service technician.

If as a result of fl ooding or a water leak there is water in the bottom container, pour it out
before turning on the dishwasher again.