49
STACKING INCUBATORS
Use the following procedure to stack incubators. This work is potentially dangerous, so contact our sales
representative or agent.
CAUTION
Select a floor that is strong enough to support the stacked incubators.
Never stack 4 or more incubators.
Doing so is dangerous.
(When stacking 2 incubators)
1.
Take out 2 stacking plates A, 2 stacking plates B, 4 protective stickers, and 4 screws from accessory
bag.
Note:
Use 2 stacking plates (A and B) for each one
. Only one pair of stacking plates is provided per an
incubator, so take out the stacking plates (A and B) from both incubators.
2.
Unplug both of the incubators that are to be stacked.
3.
Remove the caps at the 2 places in the front of the top surface of the incubator that is to be on the
bottom, attach the protective stickers to the 4 corners on the top surface of the incubator that is to be on
the bottom. (Fig. A)
4.
Secure stacking plate A with the screws that are provided.
5.
Remove the front panel (4 screws, 3 connectors, 1 ground wire, 1 gas tube) from the incubator that is
to be on the top.
6.
Place the upper incubator on top of the lower one, being careful not to pinch your fingers.
7.
Make the lower incubator level by adjusting the leveling feet, and then level the upper incubator in the
same way.
8.
Secure the stacking plate A fixed to the lower incubator to the upper incubator with the accessory
screws.
9.
Remove from the back of the lower incubator the 2 hooks (4 screws) and remove from the upper
incubator the 2 screws on the lower rear panel.
10.
Use the 6 screws that were removed in step 9 to secure stacking plate B to the rear panels of the
upper and lower incubators.
11.
Replace the front panel (4 screws, 3 connectors, 1 ground wire, 1 gas tube) to the upper incubator.
12.
Use the hooks on the back of the upper incubator to prevent the incubators from falling over.
(When stacking 3 incubators)
13.
Perform again the procedure from step 3
Summary of Contents for MCO-5M Series
Page 2: ......
