Phantom MIRO LAB, Manual

Page: 50 / 106

44
Phantom Miro LAB / LC / R Series Camera Manual
Defines whether the ‘Rising Edge’ (leading edge) or
‘Falling Edge” (trailing edge) of a TTL supplied input trigger
signal is used to trigger the camera.
Specifies the length of time (in microseconds) the trigger
signal state (high / low) must be held to be a valid trigger
signal.
Sets a delay time (defined in microseconds) between the
‘Frame Sync’ clock pulse and the frame capture to provide
a phase shift in the timing.
Sets the signal type to be activated on the ‘Auxiliary’ pin of
the capture connector.
Defines when the ‘Ready’ signal is turned off.
Adjust the color ‘Saturation’ of the images being dis-
played. Increasing the value results in the images being
displayed with more brilliant color, while decreasing the
value results in the images being displayed with less
dazzling color.
The ‘Master Black’ (Pedestal) parameter is used to change
the voltage level corresponding to black or to the maxi-
mum limit of black peaks.
‘Gain’ will raise or lower the gain in each independent
color channel when adjusted.
‘Pedestal will raise or lower the black level of each inde-
pendent color channel when selected.
‘Gamma’ will apply an independent gamma curve to each
color channel.
If ‘Trigger Polarity’ is set to ‘Rising Edge’ the
signal must be held low for a minimum of
10-times the ‘Trigger Filter’ time prior to going
high to be a valid trigger signal.
Gain, Pedestal, and Gamma settings are
applied on top of the overall gamma and color
corrections.
Trigger Polarity
Trigger Filter
Frame Delay
Aux Signal
Ready Deasserts
Saturation
Master Black
Gamma
Pedestal
Gain