9
. A.C. GENERATOR/STARTER CLUTCH
5
BR & M2 250 ENGINE
INSTALLATION
Install the starter driven gear onto the crankshaft.
Install the starter idle gear and shaft.
FLYWHEEL INSTALLATION
Install the flywheel onto the crankshaft by aligning
the key on the crankshaft with the groove in the
flywheel.
Hold the flywheel with the flywheel holder and
tighten the flywheel nut.
Torque
: 34.3
∼
39.2N-m
STATOR INSTALLATION
Install the A.C. generator stator on the right
crankcase cover and secure it with the three bolts.
Install the pulser coil on the right crankcase cover
and secure it with the two screws.
Starter Idle Gear
Shaft
Groove
•
Before installation, check and make sure
that the inside of the flywheel is not
contaminated.
*
Starter Driven Gear
Flywheel
Key
Flywheel Holder
Summary of Contents for Bug Rider BR-250
