2
1
PM 061 270 -X
RS-485
Fig. 14:
DCU connection as remote control
1
Extension cable
2
Control cable with M12 connecting plug
Connect DCU as remote control
1. Screw interface cable supplied in shipment into DCU RS-485 connection.
2. Use the PM 061 270 -X coupling.
3. Connect the interface cable to the coupling, and to the control cable from the pumping station.
5.7 Connecting accessories for the pumping station
Installation and operation of accessories
Pfeiffer Vacuum offers a series of special, compatible accessories for its products.
● Information and ordering options for approved
can be found on-
line.
● The following accessories are not included in the scope of supply.
Accessory connection for TC 110 electronic drive unit
● The use of Pfeiffer Vacuum accessories via the TC 110 electronic drive unit is
only possible using the corresponding connection cable and/or adapter on the
X3 multi-functional connection.
● Configuration of the required accessory output via RS-485 using Pfeiffer Vac-
uum display and control units or PC.
● Detailed instructions can also be found in the "TC | 110 electronic drive unit"
operating instructions.
Factory settings
All turbopump accessory connections are preconfigured at the factory. Any confu-
sion will cause malfunctions or operational failure.
1. Please note the initial product configuration.
2. Note the cable connections and parameter settings, before making changes.
Use additional accessories
1. Note the present configuration of existing connections and control cables.
2. Use the Pfeiffer Vacuum display and control unit DCU 002.
5.8 Removing transport lock
All HiCube Eco line turbo pumping stations are equipped with a transport lock for the backing pumps.
The backing pump is affixed diagonally to the pumping station baseplate, with cheesehead screws and
nuts, on 2 spring-loaded rails.
Installation
29/60
