Adjustment
70
13
.07
Position of the feed rollers to each other
Tighten screw
1.
Remove balance wheel
2
(screw
3).
Loosen two screws
4
on the bearing of the top feed roller with an Allen key (jaw width
5,
accessible through holes in the case).
Adjust screws
5
and screws
6
in accordance with the
requirement
.
Tighten screws
4
and
5.
Fit balance wheel
2
(screw
3)
and loosen screw
1.
Check the feed roller clearance, see Chapter
9.01 Adjusting the feed roller clearance
.
It is possible to check that the feed rollers are parallel to each other with a lay-
er of carbon paper between two layers of paper. For this purpose, use the “Tur-
ning the rollers” function, see Chapter
10.10 Turning the rollers
.
●
●
●
●
●
●
●
Requirement
The feed rollers
7
should be centred and parallel to each other.
Fig. 13 - 04
6
6
5
5
1
4
4
2
3
7
7