Adjustment
67
Fig. 13 - 06
1
2
2
3
5
4
6
1
●
Lock eccentric
1
by placing the locking pin
3
(part no. 13-030 272-05) in the locking hole
of the mounting bracket.
●
Switch on the machine and wait until the stepping motor has stopped running (ignore
error message on the control panel).
●
Set parameter "610" at "4" (see
Chapter 13.48.01 Selecting and changing
parameters).
●
Making sure that it is touching the rear wall, move board
4
(screw
5
) in the direction of
the arrow, until LED
6
lights up and move it back until LED
6
has just extinguished.
●
Move eccentric
1
in accordance with
requirement 2
and tighten screws
2
.
●
Switch off the machine.
●
Remove locking pin
3
.
●
Switch on the machine and check the needle drive unit in accordance with
requirement 1.
●
Switch off the machine.
●
Install needle drive unit and adjust it in accordance with
Chapter 13.10 Basic setting
of the needle drive.
Summary of Contents for 3307-1 SERIES
