REFITTING SPECIFIC COMPONENTS
Page: 20
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
To fit bearings
Note:
- the bearings and crank seals must be changed
each time the casings are opened
- when the casings are opened, if the bearings stay
on the crank, use tool P/N 755585 to remove them
- if the bearings stay in the casings, the casings
should be heated with a heat gun to remove them
This operation should be done quickly in order
to remove and refit a bearing to each casing
- Set one of the casings on its mating surface, heat
it (80 to 90°C) until the bearing drops out of its
own accord
- Remove the seal
- While the casing is expanded fit the new bearing
fully home in its housing
- Fit the new seal with tool P/N 756057
Proceed in the same way for the other casing
The seals should be positioned as follows:
- the seal on the drive pulley side 3 mm from the
outer edge of the casing
- the seal on the magneto flywheel side 6 mm from
the outer edge of the casing
