Petsafe sportdog SportHUNTER, Owner'S Manual

Page: 7 / 12

Programming the transmitter:
• Remove the transmitter battery door.
• Locate the small hole above the battery compartment.
• Insert and depress a scribe or paperclip into the hole;
observe the LED light. The LED light will blink to indicate
in which of the seven modes (shown below) the
transmitter is set. (For example, if the transmitter is set in
mode 1, the LED light will blink once. If the transmitter is
set in mode 4, the LED light will blink four times.)
• Continue to depress the scribe or paperclip until the number
of flashes on the LED light matches the mode you desire.
There will be pauses between each mode. For example,
when changing from mode one to mode three, the LED
light will first flash once, pause, flash twice, pause and
finally flash three times.
The seven modes are as follows:
Mode Black, Upper Button Function Yellow, Lower Button Function # Dogs
1* Continuous stimulation Momentary stimulation 1
Intensity level set by Intensity level set by
adjustment knob adjustment knob
2. Continuous stimulation Continuous stimulation 1
Intensity level set at its Intensity level set by
maximum, level 8 adjustment knob
3. Continuous stimulation Continuous stimulation 1
Intensity level is delivered Intensity level set by
two levels higher than that adjustment knob
set on adjustment knob
4. Tone, only. No stimulation Continuous stimulation with tone 1
Intensity level set by
adjustment knob
5. Momentary stimulation Momentary stimulation 2
DOG #1 DOG #2
Intensity level set by Intensity level set by
adjustment knob adjustment knob
6.
Continuous stimulation Continuous stimulation
2
DOG #1 DOG #2
Intensity level set by Intensity level set by
adjustment knob adjustment knob
7. Tone, only. No stimulation Continuous stimulation 1
without tone
Intensity level set by
adjustment knob
* Mode 1 is the factory pre-set default setting
6