Petsafe sportdog SportHUNTER, Owner'S Manual

Page: 5 / 12

To turn off the receiver collar, again press and
hold the activation switch for one second and
release. The LED light will stop blinking and
the receiver will “beep” twice, indicating that
the unit has been
turned off.
Resetting the Receiver
Note: Please make sure the receiver is
charged before starting.
Verify the receiver is turned off (LED is not
flashing). Reset the receiver by pressing and
holding the on/off button on the receiver
until the LED turns off. This will take 5-6 seconds. If the button is released too early,
the LED will begin flashing. If this occurs, then turn the receiver off and redo the
instructions above.
After the receiver LED has turned off, release the on/off button and press and hold the
upper, black button on the transmitter until the receiver LED blinks five (5) times. You
may need to hold the receiver and transmitter 2-3 feet away from each other before this
occurs. Once the LED blinks five (5) times, then the receiver has been reset.
If the receiver does not respond (lighting of the LED when a button is pressed), then
repeat the process.
TESTING YOUR UNIT BEFORE USING
Follow these seven steps to test your unit before
using.
1. Turn off the receiver.
2. Loosen the two contact points on the receiver until
the threading is exposed.
3. Bend the wire ends of the test light and twist them
around the exposed threading.
4. Securely hand-tighten the contact points over the
test wires.
Note: Do not overtighten the contact points over the
test wires. Overtightening may damage the test light
and cause it to function improperly.
5. Turn on the receiver. Press either
stimulation button on the transmitter. The
test light will illuminate, indicating that the
unit is operational.
6. The higher the intensity level that is set on the
transmitter, the brighter the light will shine. At the
higher levels, the receiver may emit a noise. This is
normal.
Contact Points
4
Activation switch (On/Off button)
Light will Illuminate