Programming for Two Dogs
Please program mode 5 or 6 into the transmitter (refer to the section titled
“Programming the Transmitter”)
before going any further.
You can configure either receiver to the transmitter button of your choice. Receivers
are programmed using the smaller black button and the larger yellow button located
on the transmitter. It may be easier to remember which receiver is programmed to
which button if you assign the receiver with the black collar to the black button. When
programming the receivers to the transmitter, the receiver being programmed should
be no more than two feet away from the transmitter.
For mode 5 (Momentary Stimulation for Both Receivers):
To assign the yellow button on the transmitter to a receiver, first verify the selected
receiver is off (the LED should be off), then put the receiver in programming mode
by
pressing and holding
the on/off button on the receiver until the receiver beeps
five times while the LED illuminates and then turns off. This will take 5-6 seconds.
Release the button.
If the LED begins blinking, turn the receiver off and begin this section
again, making sure to hold the button until the LED shuts off.
The receiver is now ready
for programming.
Press and
release
the yellow button on the transmitter
repeatedly
until the receiver LED blinks five times. This will indicate the receiver is now on and
programmed to the yellow button. The LED will now blink until the receiver is turned
off. Any time you press the yellow button when that receiver is on, the LED on that
receiver will illuminate and the dog will receive a momentary stimulation.
To assign the black button to the second receiver, follow the same steps just mentioned
substituting the black button for the yellow button.
For mode 6 (Continuous Stimulation for Both Receivers):
To assign the yellow button on the transmitter to a receiver, first verify the selected
receiver is off (the LED should be off), then put the receiver in programming mode
by
pressing and holding
the on/off button on the receiver until the receiver beeps
five times while the LED illuminates and then turns off. This will take 5-6 seconds.
Release the button.
If the LED begins blinking, turn the receiver off and begin this section
again, making sure to hold the button until the LED shuts off.
The receiver is now ready for
programming. Press and hold the yellow button on the transmitter until the receiver
LED blinks five times. The receiver is now on and programmed to the yellow button.
The LED on the receiver will now blink until the receiver is turned off. Any time
you press the yellow button when that receiver is on, the LED on that receiver will
illuminate and the dog will receive a continuous stimulation.
To assign the black button to the second receiver, follow the same steps just mentioned
substituting the black button for the yellow button.
7
Summary of Contents for sportdog SportHUNTER
Page 1: ...SportHUNTER OWNERS MANUAL TM TM...
Page 2: ......
