INITIAL SET-UP
Step I - Charge the Receiver
• Remove the rubber protection cap
covering the charging jack on the
SR-200I receiver.
• Plug the charger into a standard
120V AC wall outlet.
• Connect the charger connector into
the charging jack.
• Charge for 24 hrs. at room temperature.
Recharges take 12 hrs. Receiver
must be charged prior to first use.
• Once charging is complete, replace the
rubber cap protecting the charging jack.
Step II - Insert Battery into Transmitter
• Using a screwdriver or coin, loosen the two screws covering the battery door located
on the back of the transmitter.
• Press downward on the battery door and slide open.
• Connect a 9 volt alkaline battery.
• Slide the battery door back onto the transmitter and securely tighten the two screws.
Step III - Activate the Receiver
• To activate the receiver after charging, firmly press and hold the receiver’s activation
switch for one second until the LED light shines red and the receiver beeps five times.
• Release the activation switch. The receiver LED light will blink until the unit is turned
off.
• The receiver is now ready to receive signals.
3
Charger connector placed
in receiver charging jack
Summary of Contents for sportdog SportHUNTER
Page 1: ...SportHUNTER OWNERS MANUAL TM TM...
Page 2: ......
