Customer Care Center 1-800-732-2677
16
Installation in a Non-Glass Door
Determine Pet Door Location
Note:
Disconnect power adapter from pet door (or remove rechargeable battery if using) and
disconnect the motion sensor wire from exterior frame prior to installation.
1A
Measure and mark your pet’s shoulder height on the interior side of door. Draw a level line at your
pet’s shoulder height.
1B
Determine location for the pet door. Draw a vertical center line through the shoulder height line
using a level.
Helpful Tip:
Mark shoulder height and vertical center line lightly with a pencil or on a piece of tape
so marks can easily be erased or removed.
Preparing Door
2A
Remove door by removing door hinge pins.
2B
Place on a raised level surface such as saw horses. Place interior side of door facing up.
Helpful Tip:
Clamp down or weight the door to prevent it from moving. The Pet Door can be
installed with the door hanging based on your skill level.
2C
Match the marked lines on the door with the shoulder and center lines on the template. Tape the
template in place and carefully trace template. Make sure to trace underneath tape and connect the
corners. Remove the template and any excess tape from the door.
1A
1B
• Read this entire guide prior to cutting or modifying an opening in your door or wall. Do not proceed with cut-
out or installation until your pet door is assembled, powered up, programmed for your pet, and all steps under
“Prepare, Setup and Test” have been completed.
• If homeowner’s door or other application is not level, the pet door must be installed level to swing properly.
2A
2B
2C
When applying cutting template there should be a minimum of 3 inches between the
bottom and sides of the door and the outer edge of the cutting template to maintain the
structural integrity of the door.
Step 1
Step 2
