Permobil M300 Corpus HD, Service Manual

Page: 7 / 112

7
Covers
Removing the rear chassis cover
1. Switch off the main power switch on the
control panel.
2. If the upper chassis cover isn’t removed,
remove it’s rear knobs and lift it’s rear end to
release the rear chassis cover, raise the seat
if needed. Remove the rear chassis cover by
lifting it upwards/backwards.
3. On wheelchairs equipped with lights, disconnect
the rear lights cabling (see fig. below.).
Covers
Removing the front chassis cover
1. Move/fold the leg rests out.
2. Switch off the main power switch on the
control panel.
3. Remove the two knobs that hold the cover in
place (see fig.).
4. Lift the lower edge of the cover upwards/
forwards. Note that the cover is mounted
partially inside the chassis at the lower edge.
Assembly
Assemble in the reverse order.
1. Fit the cover partially inside the chassis at the
lower edge (see fig.).
2. Fit the two knobs that hold the cover in place
(see fig.).
The rear cover is fitted with the
upper chassis cover.
Assembly
Assemble in the reverse order.
1. On wheelchairs equipped with lights, reconnect
the rear lights cabling (see fig.).
2. Fit the cover partially inside the chassis at the
lower edge (see fig. above).
3. Make sure the upper cover holds the rear cover
and Remount the two knobs (see fig. above).
The front cover is fitted with two knobs.
Rear lights cabling connections.
1. Left rear Indicator
2. Right rear Indicator
3. Left rear Light
4. Right rear Light
1 2
3 4