30
30
Electric seat lift/Fixed Seat Tube
Electric Seat lift/
Fixed Seat Tube
Removal
1.
Raise the seat to the highest position. If the
wheelchair is equipped with a fixed seat post or
if the seat lift does not work normally because
the batteries are discharged or the adjustment
device is defective, the seat can be raised/
lowered manually.. See page 29.
2.
Switch off the main power switch on the
control panel.
3.
Remove the upper chassis cover. See page 9.
4.
Remove the seat including the seat tilt
mechanism if the wheelchair is equipped with
such device. See page 48.
The Fixed Seat Tube/Electric Seat Lift is attached with four screws.
5.
Remove the four fixing screws (see fig. below).
6. Electric seat lift on wheelchair with VR2
Separate the seat lift cabling at the contacts
on the cabling.
Electric seat lift on wheelchair with R-net
Disconnect the seat lift cabling from the ICS
general module.
7.
Lift the Electric Seat Lift/Fixed Seat Post
straight up out of the chassis.
ICS General Module.
ICS General Module is fitted at
the rear of the chassis.
For this task the following tools are necessary:
1 Allen key 5 mm.
The seat is heavy. This work should therefore
always be performed by two people. Be careful
with the cabling.
m
WARNING!
Summary of Contents for M300 Corpus HD
