22
Link arms
Fitting/removing the Rear Link Arm.
Link arms
Removal of rear link arms
1.
Switch off the main power switch on the
control panel.
1
Rear Link Arm.
2
Washer, 32x8,1x3
3
Screw ISO 4762 M8x20 8.8 Fe/Zn
4
Cover
Item
Description
1
For this task the following tools are necessary:
1 Allen key 6 mm.
2.
Lift up and chock up the wheelchair chassis so that the wheel in question is free of the ground.
3.
Remove the drive wheel. See page 16.
4.
Remove the lower shock absorber bracket (4) (see fig.).
5.
Remove the reinforcementbar (1), it’s fitted with two screws (see fig. below).
6.
Remove the link arm (2).
For removal of wheel forks and wheels, see the respective chapters.
Assembly of rear link arms
Assemble in the reverse order.
1.
Check that the axle and link arm are not damaged. If necessary, clean to remove dirt and rust.
Replaced damaged parts.
2.
Fit the link arm on the axle using just your hands. Check that the guide (3) of the rear link arm is
correct positioned in the groove of the front link arm and that the link arm is fully located on the axle
(see fig. below).
3
2
3.
Remount the reinforcementbar (1), it’s fitted
with two screws (see fig. below). Tighten the
screw with a torque wrench.
Tightening torque: 17.7 ft-Ibs (24Nm)
5.
Fit the lower shock absorber bracket (4) (see
fig.).
6.
Fit the drive wheel. See page 16.
4
Summary of Contents for M300 Corpus HD
