20
Slewing brackets
Slewing brackets
Removal
1.
Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 38. If the seat lift does not work normally
because the batteries are discharged or the
actuator is defective, the seat can be raised/
lowered manually, see page 30.
2.
Switch off the main power switch on the control
panel.
3.
Remove the seat lift cover, chassis cover
and the front fender on the side in question,
see page 7.
4.
Lift up and chock up the wheelchair chassis
so that the wheel in question is free of the
ground.
5.
Remove the front wheel, see page 10.
6.
Disconnect the electrical connection for the
drive motor and the magnetic wheel lock. The
connections are positioned on the inside of the
chassis, on each side of the seat lift/seat post,
see fig.
7.
Disconnect the wheel lock release cable
8.
Remove the shock absorbers front bracket,
see fig.
The electrical connection for the drive
motor and the magnetic wheel lock.
The shock absorbers front bracket.
The electrical connections of the drive
motors and the wheel locks are positioned
on the inside of the chassis, on each side of
the seat lift/seat post.
Summary of Contents for C500
