Pepwave BR1 ENT, User Manual

Page: 117 / 206

Outbound
Mappings
This setting specifies the WAN IP addresses that should be used when an IP connection
is made from a LAN host to the Internet. Each LAN host in an IP range or IP network will
be evenly mapped to one of each selected WAN's IP addresses (for better IP address
utilization) in a persistent manner (for better application compatibility).
Note that if you do not want to use a specific WAN for outgoing accesses, you should still
choose default here, then customize the outbound access rule in the
​ Outbound Policy
section. Also note that WAN connections in drop-in mode or IP forwarding mode are not
shown here.
Click ​ Save ​ to save the settings when configuration has been completed.
Important Note
Inbound firewall rules override the
​
Inbound Mappings
​
settings.
18 QoS
18.1 User Groups
LAN and PPTP clients can be categorized into three user groups: ​ Manager, Staff, and Guest ​ .
This menu allows you to define rules and assign client IP addresses or subnets to a user
group. You can apply different bandwidth and traffic prioritization policies on each user group
in the
​ Bandwidth Control ​ and ​ Application ​ sections (note that the options available here vary
by model).
The table is automatically sorted by rule precedence. The smaller and more specific subnets
are put towards the top of the table and have higher precedence; larger and less specific
subnets are placed towards the bottom.
Click the ​ Add ​ button to define clients and their user group. Click the button to remove the
defined rule. Two default rules are pre-defined and put at the bottom. They are
​
All DHCP
reservation clients ​ and ​ Everyone ​ , and they cannot be removed. The ​ All DHCP reservation
client represents ​ the LAN clients defined in the DHCP Reservation table on the LAN settings
page.
​
Everyone
​
represents all clients that are not defined in any rule above. Click on a rule to
change its group.
http://www.peplink.com 117 Copyright @ 2017 Pepwave