AS-Interface
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Is
s
ue dat
e -
12.
8.
2007
34
Meaning of the displayed mode:
Enable:Automatic address programming is released.
Disable:Automatic address programming is locked.
With "Change" the operation mode can be changed.
7.5.12
Factory reset
F A C T O R Y R E S E T
D O R E S E T
With this function the master can be reseted to the factory setting. The reset can
be chosen by selecting the menu entry "DO RESET".
7.6
IO + Param. Test
7.6.1
AS-i circuit
A S - I C I R C U I T 1
A S - I C I R C U I T 2
To reach this setup menu you have to change the desired AS-i circuit by using the
arrow and the OK buttons.
The function is only implemented in the double master.
It makes possible to change the AS
-
i circuit that is currently active for being ope-
rated.
The active circuit is marked by the cursor.
• This function should be used only in an emergency, since all attitudes trans-
acted so far are put back to factory setting and thus perfect communication
and functioning of the masters with the AS-i circle are ensured no more.
• The master and the AS-i circuit have to be recommissioned and reprojected
again after a successful "Reset".
• In case of double masters the "Reset" acts on both AS-i masters!
