Iss
u
e d
a
te
: 21
.1
0.2
011
100
Subject to reasonable modifications due to technical advances.
© Fuchs, Printed in Germany
Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
Internet http://www.pepperl-fuchs.com
AS-i Safety Monitor for 2 AS-i circuits
Codes indicated by the display
13.
Codes indicated by the display
In the basic state of the configuration mode, the addresses of all detected slaves
are displayed in two-second intervals. A blank display indicates that the LDS (List
of Detected Slaves) is empty, no slaves were detected.
In the basic state of the protected operating mode, the display is either blank or
displays the address of a faulty assignment.
During manual address programming, the slave address display has a different
meaning (see also chapter "Operating in advanced display mode").
All displayed numbers bigger than 31 which can not be interpreted as a slave
address are status or error messages of the master. They have the following me-
anings:
39
Advanced AS-i diagnostics: After pressing the ’set’-button a short-time AS-i
power failure occurred.
40
No AS-i Master connected or AS-i power fail.
41
AS-i Master is connected.
68
Hardware error: disturbed internal communication.
69
Hardware error: disturbed internal communication.
70
Hardware error: The AS-i master’s EEPROM cannot be written.
71
Wrong PIC-type.
74
Checksum error in the EEPROM.
75
Error in the internal RAM.
76
Error in the external RAM.
79
Checksum error in the data menu.
88
Display test while starting up the AS-i master
Tab. 13-32.
Summary of Contents for VAS-2A1L-K31
Page 107: ...VAS 2A1L K31 VAS 4A16L K31...
