PEP Modular Computers CP331, Manual

Page: 44 / 44

CP331 Configuration
ID 19947, Rev. 0200 Page 4 - 4
©
2000 PEP Modular Computers GmbH
4.3 Panel Selection
Two following display type (panel) configurations are supplied by default. They can be
selected directly by setting the wire jumpers that are part of connector ST1 or, alterna-
tively, the solder jumpers J7 through J10 on the board reverse side:
• NEC NL 8060AC31-12
• SHARP LQ 150X1DG11
The jumper settings necessary to select one of these panels are shown in the following.
Panel numbers refer to BIOS panel numbering. Panel numbers 7 and 8 correspond to preset panel types.
Default settings are in italics.
Table 4-2: ST1/J6..J13 Jumper Settings
ST1 Pins Function Alternative Solder Jumper
7 - 8 Panel type bit 0 J10
9 -10 Panel type bit 1 J9
11 - 12 Panel type bit 2 J8
13 - 14 Panel type bit 3 J7
Table 4-3: Display Type Selection
N° Panel Parameters/Type
ST1 13-14
J7
ST1 11-12
J8
ST1 9-10
J9
ST1 7-8
J10
1 1024 x 768 DSTN Color Closed Closed Closed Closed
2 1280 x 1024 TFT Color Closed Closed Closed Open
3 640 x 480 DSTN Color Closed Closed Open Closed
4 800 x 600 DSTN Color Closed Closed Open Open
5 640 x 480 SHARP TFT Color Closed Open Closed Closed
6 640 x 480 TFT Color 18-bit Closed Open Closed Open
7
SHARP LQ 150X1DG11
1024 x 768 TFT LCD
Closed Open Open Closed
8
NEC NL 8060AC31-12
800 x 600 TFT LCD
Closed Open Open Open
9 800 x 600 TFT Color Open Closed Closed Closed
10 800 x 600 TFT Color Open Closed Closed Open
11 800 x 600 DSTN Color Open Closed Open Closed
12 800 x 600 DSTN Color Open Closed Open Open
13 1024 x 768 TFT Color Open Open Closed Closed
14 1280 x 1024 DSTN Color Open Open Closed Open
15 1024 x 600 DSTN Color Open Open Open Closed
16 1024 x 600 TFT Color Open Open Open Open
Note: The logical panel code values are inverted, i.e. “closed” is equal to 0, “open” to 1.