Pentax K-5II, Operating Manual, Page: 188 / 336

186
Sho
o
ting
Setti
ngs
6
4
Press the shutter release button fully.
Set the focus mode to \ when the shutter cannot be released.
The screen to select the measuring range is displayed.
5
Use the rear e-dial (
S
) to select
the entire screen or spot area for
the measuring range.
6
When a spot area is selected, use the four-way controller
(
2345
) to move the frame to the position you want to
measure.
7
Press the
4
button.
The white balance is measured, and the screen that was displayed in
Step 3 appears again.
Adjust the white balance as necessary.
The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the
4 button to remeasure the
white balance.
8
Press the 4 button twice.
The camera is ready to take a picture.
• If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted. In this case, adjust exposure to the correct amount level
before adjusting the white balance.
• When the mode dial is set to
C
(Movie), the white balance cannot be
measured. Adjust the white balance in any exposure mode other than
C
before recording a movie.
Cancel OK OK
MENU
1 1