27830 -27/40-
FINAL ADJUSTMENT AND CONFIRMATION
1. [CONF.] Static Current
[Required equipment] Regulated power supply, Circuit tester, DC power adaptor (Hand made,
refer to “Table of jig and tool” on p.40.)
[CONF.] Set regulated power supply to DC5.5V (over 3A). Make sure not exist any shortage or
leakage in the circuit.
Static current : Main SW/off
･･･
under 50
μ
A.
Main SW/on (Light metering off)
･･･
under 380
μ
A.
2. [CONF.] Function Check
[Preparation] Apply the power to the body.
[CF: Custom function, AEB: Auto bracketing, SI: Superimpose]
1) Main SW, Release SW and Shutter
①
Turn the main SW ON, confirm the LCD display showing focus points and drive mode, etc.
②
Turn the preview SW ON, make sure that the diaphragm actuate lever (0-G100) swings up
completely.
③
After turning the main/preview switch to ON position, the LCD panel should be lighted up.
(When setting the custom function to [CF15]- [3], illumination function is turned OFF.)
④
When depressing the release button halfway, confirm showing the Tv /Av information on
the LCD panel and viewfinder indications should stay on for approx. 10 sec.
⑤
Set the mode dial at M position and slower (ex. 1sec) shutter speed. Make sure that the
shutter curtain opens by releasing the shutter.
2) Av SW
・
AE-L SW
・
Select dial
①
Set the mode dial at AUTO PICT position.
②
By depressing “Av” button, the bar graph indicates in the viewfinder and on the LCD panel.
At the same time, the exposure compensation should be able to set by select dial.
③
By depressing “AE-L” button, AE lock mark “
＊
” indicates in viewfinder. When depressing
“AE-L” button again, AE lock mark “
＊
” should be able to canceled.
3) Mode
dial
①
Set the mode dial at AUTO PICT position and FA (F) lens at “A” position. After turning the
main switch from OFF to ON position, the illumination of mode dial (LED) lights up.
②
By turning the mode dial, the LED for each picture mode lights up accordingly.
③
Set the mode dial at Tv/Av mode, Tv and Av display should be able to changed by select
dial.
④
Set the mode dial at M mode, Tv display should be able to changed by select dial with
indicating the bar graph.
⑤
Set the mode dial at ISO or
, the ISO film speed and the audible PCV signal should be
able to selected by the select dial.
⑥
Set the mode dial at CUSTOM position, CF should be able to set by four-way control key.
4) Back cover SW and Film winding/rewinding
①
Load a test film (36 ex.), close the back cover and turn the main switch ON. Then confirm
the operation of winding, exposure counter and rewinding.
②
Make sure that rewinding the film starts when the mid-roll rewind button is pressed.
5) Flash
check
①
By depressing the flash button, the flash pops up with indicating the flash ready mark.
②
Make sure that the flash fires by releasing the shutter.
