27830 -17/40-
4-5. [ADJ./CONF.] 0-O100 Position
[CAUTION] Note miss wiring, wrong polarity and short circuit, because the following 5 lead
wires are soldered to 0-T100 directly.
1
）
Solder 5 lead wires to 0-T100.
[60mm or more (x1), 160mm or more (x2), for power supply (x2)]
2
）
Short the main switch lands on 0-T100 by soldering.
3
）
Solder 1k
Ω
resistance to the place instructed in Fig.85.
4
）
Connect the flexible board of 0-O100 with 0-T100.
5
）
[CONF.] When applying DC5.5V, all indications will be lighted as
as
shown in Fig.84, and check the position and inclination of display.
Fig.83
Fig.84
6
）
[ADJ.] Adjust the position of 0-O100 by loosing two screws as shown in Fig.83.
7
）
After adjustment is done, apply screw-lock agent to screw thread, and then remove the lead
wires from 0-T100.
Fig.85
(-)
DC5.5V
(+)
60mm
160mm
160mm
Soldering
(Main SW land)
1kΩ
1kΩ
SL
