9
SunTouch
®
Control System Installation and User’s Guide
Freeze Protection in Solar Only mode
The SunTouch
®
Control System freeze protection function is active once the optional air sensor is
installed and enabled (see page 8). Freeze protection is enabled whenever the outside temperature
is 36º F or lower. When freezing conditions are detected by the air sensor the filter pump will be
switched on and water will circulate continuously through the system. It’s important that the air
sensor be permanently placed in the shade and away from windy locations. In the event of a power
failure, the system will be unprotected. Recirculating water to protect your system from freezing is not
recommended in climates where freezing temperatures occur frequently and last for extended periods.
Operating in Pool/Spa mode (Shared Equipment)
Pool/Spa Mode
Using the SunTouch Control System in the Pool/Spa mode allows pool and spa operations to be fully
automated. The menu features let you create customized schedules for your pool and spa equipment,
heat temperatures and chlorination settings to switch on and off at a time and day. For maintenance and
service purposes, the control panel allows manual control of all pool and spa operations.
Setting up the SunTouch
®
Control System to Operate in Pool/Spa Mode
To setup the SunTouch
®
Control System to operate in Pool/Spa mode (shared equipment):
Press the
LEFT
arrow button to save and exit the main menu.
Note: For the Pool/Spa menu settings, see
page 12.
Adjusting the Water Temperature Setting in Pool/Spa Mode
After setting the pool water temperature in the Heat menu (see page 14), you might occasionally need to
adjust the water set point temperature. Use the
(-) TEMP
and
(+) TEMP
buttons to set the water to the
desired temperature.
To adjust the spa set point water temperature:
Press the
Spa (Up arrow)
button to display the actual and
set point water temperature settings. As shown below, the heat setting displayed on the left side (71° F)
is the actual water temperature and on the right side the set point temperature (91° F) is displayed. The
set point temperature is set in the Heat menu.
Note: For Information about selecting the heat source,
refer to “Selecting the Heat Source” on page 10.
Press either
Up or Down
button and select
“Pool/Spa”
Press the Right
button to save and
exit.
Main Menu 8/14
Advanced
SunTouch
11: 51 AM
▼
MENU
MENU
▼
System Mode
Pool/Spa
Press the MENU button to
access the Main Menu items
Press the MENU button
until “Advanced” displays
Press the Right button to
access the “System Mode”
options
CAUTION
If you live in a location where freezing conditions occur and there is no air sensor installed
or the air sensor is not enabled, your system will be unprotected.
SPA 71°F / 91°F
11: 51AM HEATER
▼
Set
temperature
Lower water set
point temperature
Actual
temperature
Heater
activated
AIR 59°F
11: 51 AM
Spa
button
Raise water set
point temperature