INSTALLATION INSTRUCTIONS
28
Always check to make sure that the appliance has an efficient earth ground system. This requirement is
only satisfied if it has been properly connected to an efficient ground system installed in accordance with the
requirements of current safety standards and carried out by professionally qualified personnel.
This basic safety measure must be checked, verified and carried out by professionally qualified personnel. Have
the electrical system checked by a qualified electrician. The manufacturer will not be held liable for any
damage or injury caused as a result of an inefficient or faulty earth ground system.
■ Ensure the domestic power supply is checked by a qualified electrician to ensure that it can support the
maximum power absorption of the appliance, as indicated on the rating plate. In particular, make sure that the
cable sizes are adequate for the power absorbed by the appliance;
■ The power supply cable must be replaced by a qualified electrician. If the cable is damaged in any way, switch
off the appliance and have the cable replaced by a suitably qualified electrician;
When using an electrical appliance, a few fundamental rules must be observed:
Do not touch the appliance with damp or wet parts of the body or when barefoot.
Do not pull on the electric wires.
Do not allow the appliance to be used by children or anyone unfamiliar with its operation;
If the unit fails to re-start after any fault and you have already pressed the reset “R” button,
unplug the unit for 30 seconds, then re-plug in the unit and try to restart with the on/off switch.
If the unit fails to restart, call a qualified Technician for service. DO NOT ATTEMPT ANY
REPAIRS ON YOUR OWN.
Summary of Contents for PNCC-32N
