Prima 320 Advance
61
User Manual
6.7
Alarm Setup
Use the Alarm setup menu to set and adjust alarm limits and
to view alarm history. See section 6.11.6 for alarm messages.
6.7.1 Set Ventilator alarm limits
1. Select the [Alarms] hotkey and select the Limits 1 screen.
2. Set upper and lower limits respectively for each
parameter, and exit the menu.
6.7.2 Set
CO2 alarm limits
If a CO2 module (optional) is fitted, select System: >Settings.
1. Set ‘CO2 alarms’ to On.
2. Select the [Alarms] hotkey and select the Limits 2 display.
3. Set upper and lower limits respectively, and exit the menu.
6.7.3 Set SpO2 alarm limits
If a SpO2 module (optional) is fitted, select System: >Settings
1. Select SpO2 alarm to On.
2. Select the [Alarms] hotkey and select the Limits 2 display.
3. Set upper and lower limits respectively, and exit the menu.
6.8 Trends
A trend graph is used to review parameter values within a
specific time period. The trend is reflected through a curve.
Every point on the curve corresponds to the parameter value
at a specific time point. You can review parameter data within
a maximum of a 24-hour operating period.
Select the [Trends] menu (1) to access the display
a) Time Scale button
b) Parameter selection button
c) Trend graph
d) Cursor
e) Parameter value
f) Cursor position time
Setting
1. Use the Time Scale button (a) to select the desired time
scale (1, 4, 12 or 24 hours).
2. Use the Parameter selection button (b) to select the
desired parameter.
3. Use the multifunction control to reposition the cursor (d),
to view the parameter values at the required time point.
CAUTION
1. If system time is set, the trend graph is recorded again.
2. If ‘Patient type’ is reset, select save or record again.
Operating the Anaesthesia System
e
f
b
a
c
d
1
