Arctica 3200xlp switch Installation Guide Chapter 3 Device Installation
5
Figure 3
-
5 Connecting Console to Arctica 3200xlp 40Gb Routing switch
The connection procedure is listed below:
1. Find the console cable provided in the accessory kit. Attach the console cable end to
console port of the switch.
2. Connect the other side of the console cable to a character terminal (PC).
3. Power on the switch and the character terminal. Configure the switch through the
character terminal.
3.2.5.QSFP+ Transceiver Installation
Arctica 3200xlp provides 32 QSFP+ ports.
The procedure for installing the QSFP+ transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves)
Step 2: Insert the QSFP+ transceiver to the guide rail inside the QSFP+ port. Do not put
the QSFP+ transceiver up-side-down.
Step 3: Push the QSFP+ transceiver along the guide rail gently until you feel the
transceiver snap into place at the bottom of the QSFP+ port.
Note: the QSFP+ transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bore in the QSFP transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
