pellenc SELION M12, Translate Of The Original Manual

Page: 26 / 51

CHAINSAW SELION M12
51_149238-C
5.4. HOLDING THE TOOL
1. Take the chainsaw by the handles and ensure noth-
ing is touching the chain.
2. Attach the power supply cord to your arm using the
supplied armband.
3. The chainsaw is in its “start-up” position.
Warning
Never disconnect the power cord
from the battery without checking that
the On / Off switch is in the off position
«0».
Caution
Do not cut anything other than wood.
Always keep your left hand on the front handle.
5.5. START-UP
Note
The indicator on the rear handle indicates that the tool is switched on
Caution
Always start the motor before bringing the chainsaw into contact with the wood.
1. Remove the chain guide protector.
2. Set the Pellenc tool battery On/Off switch to the On position “I”. From the moment the indicator light (12) comes
on, the tool is energized and ready to operate.
3. Keep the safety trigger (3) pressed while holding the chainsaw by the rear handle with your right hand and the
front handle with your left hand.
4. In order to guarantee chainsaw safety when relocating, an electronic device blocks the motor control 3 seconds
after the motor is stopped. Press the trigger (2) twice consecutively to restart the motor. The chainsaw chain
continues to turn as long as the trigger (2) is maintained pressed.
5. Release the trigger (2) to stop the motor.
Warning
When either the guide or the chain is replaced, they must be run in by operating the tool with-
out sawing for 1 to 2 minutes. Check the chain tension after the running-in phase, see page Sec-
tion 6.5, “Automatic chain tensioning”.
26