pellenc SELION M12, Translate Of The Original Manual

Page: 34 / 51

CHAINSAW SELION M12
51_149238-C
6.6. CHAIN LUBRICATION
6.6.1. FILLING THE CHAIN OIL RESERVOIR
Before the first use, it is essential to fill the chain oil reser-
voir with the specific chain and guide oil (Ref.: 116688)
1. Unscrew the guide and chain oil reservoir cap (9)
2. Carefully pour the guide and chain oil into the reser-
voir.
3. Tighten the chain oil tank cap (9)
Important
Check the oil level every hour and top it up if nec-
essary.
Note
PELLENC recommends using a biodegradable chain oil that complies with the RAL-UZ-48 standard (ref.
116688, otherwise any oil that complies with the RAL-UZ-48 standard)
Consumables sold separately.
Warning
Never use dirty or used oil.
6.6.2. FIRST FORCED LUBRICATION CYCLE
The forced lubrication cycle distributes the oil from the
reservoir to the different components. It is imperative to
carry out this forced lubrication cycle before first use of
the Chainsaw Selion M12.
1. Press and hold the triggers (2) and (3).
2. Switch on the battery (see Section 5.3, “Switching
the battery on and off”.)
3. An automatic cycle starts which sends oil from the
reservoir to the chain guide.
a. short beep every 20 seconds during the cycle.
b. 3 beeps to validate the end of the cycle.
4. Release both triggers when the first beep sounds
Warning
Carry out a forced lubrication cycle at the start of each season in order to check the chain
lubricating function. Carry out forced lubrication whenever necessary.
34