pellenc SELION M12, Translate Of The Original Manual

Page: 21 / 51

CHAINSAW SELION M12
51_149238-C
4.8. FITTING THE BATTERY ON THE HARNESS
To mount the battery on your harness, refer to the mounting instructions provided with your harness.
Important
After mounting, the battery must be solidly attached and secured on your harness. If this is not the case then
the mounting needs to be re-checked.
4.9. CONNECTING PELLENC BATTERIES TO THE TOOL
Important
Always check the remaining battery-life before use. If necessary, recharge the battery using the charger.
To prolong the life of the connectors, it is advisable to protect them when they are disconnected. Avoid leaving
the connectors in contact with abrasive or dirty surfaces, or subjecting them to major impacts (falls).
4.9.1. ULIB 250 BATTERY
1. Connect the power cord (10) of the Chainsaw to the
connector on the battery.
2. Screw it in all the way.
3. Check that the power cord is properly connected.
4.9.2. ULIB 750 / ALPHA 260 / ALPHA 520 BATTERIES
1. Connect the power cord (10) of the Chainsaw to the
red connector of the quick connector adaptor (ref.
57262).
2. Screw it in all the way.
3. Check that the power cord is properly connected.
21