Pellas X HYBRID 44, User Manual

Page: 6 / 39

4 | P a g e

During storage, the device can not have direct contact with the floor. Pellas X
burner until final assembly should be kept in carton and on a pallet. Burners can be
stored and transported in three layers maximum.
 In case when a burner is stored for over 2 years from its production date or in
environmental conditions not similar to above description, before installing it should
be subject to activating - test by an authorized service person. To testify proper
quality and safety of a burner, the above inspection will be documented by service person
in the guarantee card.
1.3. Control of burner’s delivery
Before commencing assembly activities check the following: condition of packaging, make
sure that there are no visible damages and if delivery is complete and not damaged.
Possible reservations and problems should be reported to the supplier immediately. He is
responsible for insuring the merchandise.
1.4. Free space around burner
According to local safety regulations referring to heating devices, provide free space
around burner, at least 1 m around boiler and space for service of burner.
The boiler room should be clean, dry and well aired. Airflow to the boiler should be at
least equal to exhaust of fumes through the chimney.
ATTENTION!
Controller and all devices cooperating with it should be installed on the boiler or its
area, in places where the temperature is the lowest (below 50
⁰
C). Electronic devices
operating at high temperature may be damaged or not work properly.
ATTENTION!
In order to minimize the risk
of fire is not allowed to store
flammable materials
near the burner
(minimal length 1m).