Peg-Perego Viaggio 0+1 Convertibile, Instructions For Use Manual

Page: 22 / 44

22
suddenly, it could injure the passengers.
• Do not use the car seat if more than seven years have
elapsed from the date on the frame. The natural aging
of the materials may mean the car seat does not
comply with the laws on safety any more.
• Do not use accessories that have not been approved of
by the manufacturer or competent authorities.
Instructions for use
UNIVERSAL CATEGORY - Belted
Group 0+
Fastening with seat belts
1• For the correct use of the Viaggio 0+1 Convertible car
seat in Group 0+ mode, you must:
- Extract, from under the seat, the recline body. To
extract it, press the handle and pull it towards you
extracting the base (arrows A and B).
- Use the lever (arrow C) to recline the seat to its highest
position.
2• Viaggio 0+1 Convertible car seat correctly structured to
be used as Group 0+ car seat.
3• Apply the Viaggio 0+1 Convertible car seat on the seat
so that it is rear-facing, as shown in the picture.
Fit the car seat belt between the frame and the seat
following these steps:
_ slip the belt into the webbing guides first (arrow A);
_ fasten the seat belt to the seat until it clicks (arrow B);
4• thread the seat belt in the blue webbing slot on top
(arrow C).
IMPORTANT: hold the belt and pull it firmly, so
that the Viaggio 0+1 Convertible is as close as possible
to the car seat (arrow D).
Instructions for use
UNIVERSAL CATEGORY - Belted
Group 1
Fastening with seat belts
5• Place the Viaggio 0+1 Convertibile car seat on the
vehicle’s seat, facing in the normal direction of travel of
the vehicle, as shown in the figure.
6• To make it easier to pass the vehicle’s safety belts
through the back of the car seat, it is necessary to
recline the seat to the lowest position by operating the
lever, as shown in the figure.
7• Pass the vehicle’s safety belt between the frame and
the shell of the car seat.
8• The lap belt must pass through the low slots marked in
red. Fasten the belt, ensuring that it clicks into place.
9• The figure shows Viaggio 0+1 Convertibile fitted in a
vehicle.
10• Check that the lap belt has gone through the low slots
marked in red and tighten it (Fig. A).
11• To complete the securing procedure in a vehicle, use
the Steady Fix device. Open the clip and pass the
diagonal strap through it, ensuring that it is taut and
not twisted (Fig. B). Close the safety tab (Fig. C).
12• IMPORTANT: Take hold of the safety belt and pull
it upwards firmly to fit Viaggio 0+1 Convertibile
more closely to the seat of the vehicle (Fig. D) .
Once the procedure is complete, it is possible to
recline the seat to the desired position (See Point 6).
How to put the child in the Viaggio
0+1 Convertibile car seat
13• Before sitting the child on the stroller, release the safety
harness by pushing the red button in the buckle of the
leg divider strap.
14• Lift the safety harness and attach the buckles to the
elastics in the sides.
15• Sit the child in the stroller and adjust the safety straps
round the child’s shoulders and waist, as shown in the
picture.
16• Fasten the harness by overlapping the two straps and
inserting the buckles into the leg divider strap until
they click into place.
17• The child is sitting correctly with the safety harness
fastened properly.
18• To complete installation, check the safety belts are
not too loose by pulling the central adjusting belt as
shown in the picture. Make sure the safety belts are not
too tight.