Peco 28131502, Operator'S Manual

Page: 7 / 46

Preparation of Mower (Continued)
Before beginning installation, remove the mower’s pre-existing hardware on the mower’s rear frame bumper along
with the mower’s fuel tank guard. Refer to Figure G.
Then, loosen, but do not remove, the bolts on both side of the rear frame tubing shown in Figure I. This will allow for
an overall easier Unit Installation.
Figure G
Remove
Fuel Tank
Guard
Remove
Hardware
Right Side View
Note: Set aside the (2) bottom sets
of hardware for the installation of
the Mount Arm
Figure I
Loosen
Hardware