Peco 28131502, Operator'S Manual

Page: 20 / 46

20
Threaded
Boss
Blower
Cone Tab
(1st) Tighten
Bolt
(2nd) Tighten
Jam Nut
Blower
Cone
Thread (1) Jam Nut
Onto Each 5/16”-18 Bolt
Once the (2) bolts are tight, tighten the Jam Nuts against
the threaded boss as shown in Figure C.
Refer to Figure D for proper Blower Cone installation
reference.
Blower Cone Installation
Thread (1) 5/16”-18 Jam Nut P#(K0120) onto each end
of (2) 5/16”-18 x 1-1/2” HHCS P#(K1157) as shown in
Figure A.
Now partially thread (1) bolt into each of the two
threaded bosses located on the Blower Housing. Place
8” Blower Cone P#(E6009) so the two tabs line up with
the bolts and tighten completely as shown in Figure B.
Figure B
Figure A
Figure D
Figure C
Boot Kit Assembly & Installation
Secure the Boot Plate (Item#2) to the Aluminum Boot (Item#1) using (2) 3/8”-16 x 1” Carriage Bolts (Item#3) and (2)
3/8”-16 Ny-Flange Lock Nuts (Item#4). Insert the Carriage Bolts from the inside of the Boot so the threads are on the
top of the Boot. This will prevent grass clippings from collecting on the threads. Refer to Figure A.
Figure A