Peco 28131502, Operator'S Manual

Page: 11 / 46

Bottom Bracket / Mount Arm Installation
To install the Bottom Bracket / Mount Arm (Item #1), position and align the Bottom Bracket under the Top Bracket.
Align the bolt holes of the Bottom Bracket to the those located on the mower’s rear bumper. Refer to Figure A.
Secure the left of the Bottom Bracket to the mower by using (1) 1/2”-13 x 1-1/2” HHCS (Item #2), (2) 1/2” Flat
Washers (Item #3) and (1) 1/2’-13 Flange Nut. Refer to Figure B.
Secure the right side of the Bottom Bracket by using the pre-existing hardware found on the mower’s lower right rear
bumper. Refer to Figure A.
Figure A
Figure B
Remove and reuse
the pre-existing hardware
to secure the Bottom Bracket