Peco 28131502, Operator'S Manual

Page: 24 / 46

24
Wire Harness Installation
With the operator’s seat lifted, position the PTO Switch
Mount P#(B1029_01) on the fender to the left of the
operator’s seat. Refer to Figure A.
To secure the PTO Switch Plate, note the locations of
the (2) bolt holes of the Switch Plate and drill (2) bolt
holes into the fender to mount the Switch Plate by using
an “F” size drill bit (17/64”).
Secure the PTO Switch Plate by using (2) 1/4”-20 x 1/2”
HWHTCS P#(K0353) and (2) 1/4”-20 Ny-Flange Lock
Nuts P#(K2014). Refer to Figure B.
The PTO Rocker Switch P#(P0293) may be installed at
this time by positioning it over the Switch Plate and firmly
pressing the Rocker Switch down until it is seated in
place.
(1) 1/4”-20 x 1/2” HWHTCS
(1) 1/4”-20 Ny-Flange Lock Nut
Figure B
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Note: When drilling the mount holes, be
sure not to go further than the initial
material thickness.
Figure A