Peco 28131502, Operator'S Manual

Page: 25 / 46

Wire Harness Installation (Continued)
Next, route the Negative Lead (-) and the Positive Lead (+) of the Wire Harness P#(P0298) (Refer to Figure C) to the
negative & positive terminal of the mower’s battery.
Then, disconnect the mower’s clutch connector and interconnect with the Wire Harness’ Clutch Connection Jumper.
Be sure to identify and pick the correct Jumper depending on your mower’s clutch connection type. Refer to the
Wiring Diagram on Page 26 for the Connection Jumper Types.
At this time connect the Wire Harness’ (2) Female Switch Disconnects (Refer to Figure C) to the PTO Rocker Switch
P#(P0293).
Figure C
Figure D
Note: To avoid damage to the Wire Harness,
do not leave any slack that will allow the Wire
Harness to come into contact with the PTO Belt
Recommended
Zip-tie Point
Finally, route the Wire Harness back towards the rear of the mower positioning the Wire Harness under the Bottom
Bracket / Mount Arm. Then connect the Wire Harness to the PTO Unit. Refer to Figure D.
Note : It is recommended to secure the Wire Harness to the mower by using the included Cable Ties P#(J0245) once
you have the Wire Harness installed. Be sure the Wire Harness is routed so that it does not obstruct the seat as it is
being lowered down or any part of the mower that may damage the Harness.
Negative Lead (-) to
Negative Terminal (-)
Positive Lead (+) to
Positive Terminal (+)
(2) Female Switch Disconnects
to PTO Rocker Switch