Opera on Systems
Summit™ Series | SX
‐
SmartTouch™ Control
59
Page
Up
/
Down
If an Up or Down bu on is shown and pressed when on a page with a text list, the list can
be scrolled a page at a me.
Overview
Pumps
On the Spa Screen, select a “Jets” bu on once to turn the pump on or o
ff
, and to shi between low
‐
and high
‐
speeds if equipped. If
le running, the pump will turn o
ff
a er a me
‐
out period. The low
‐
speed of pump 1 runs when the blower or any other pump is
on. If the spa is in Ready Mode, Pump 1 low may also ac vate for at least 1 minute every 30 minutes to detect the spa temperature
(polling) and then to heat to the set temperature if needed. When the low
‐
speed turns on automa cally, it cannot be deac vated
from the panel, however the high speed may be started.
Filtra on
and
Ozone
Pump 1 low and the ozone generator will run during
fi
ltra on. The system is factory
‐
programmed with one
fi
lter cycle that will run
in the evening (assuming the me
‐
of
‐
day is properly set) when energy rates are o en lower. The
fi
lter me and dura on are
programmable.
A second
fi
lter cycle can be enabled as needed.
At the start of each
fi
lter cycle, the water devices like blower and other pumps will run brie
fl
y to purge the plumbing to maintain
good water quality.
Clean
‐
Up
Cycle
When a pump is turned on by a bu on press, a clean
‐
up cycle begins 30 minutes a er the pump is turned o
ff
or mes out. The
pump and the ozone generator will run for 30 minutes or more, depending on the system. On some systems, you can change this
se ng.
Freeze
Protec on
If the temperature sensors within the heater detect a low enough temperature, then the water devices automa cally ac vate to
provide freeze protec on. The water devices will run either con nuously or periodically depending on condi ons.
In colder climates, an op onal freeze sensor may be added to protect against freeze condi ons that may not be sensed by the
standard sensors. Auxiliary freeze sensor protec on acts similarly except with the temperature thresholds determined by the
switch. See your dealer for details.
U li es
Screen
U li es
The U li es Icon on the Se ngs Screen takes you
to
the U li es Screen.
Panel
Touching the Panel Icon you to the Panel Screen,
where you can set how long it takes the panel to
go to sleep a er the last ac vity. The Sleep Timer
can be set from 1 to 60 minutes. The default is
30 minutes.
Off
On
Running
High 104 F
78 F
Cleanup Cycle
Ozone
Spa State
Temp Range
Temp Limit