PCB Piezotronics Larson Davis BAS002, Manual

Page: 29 / 75

4-3 Programming Mode BAS002
• Red steady: the remote control is not in the radio range
of the amplifier. Keypad commands are transmitted by
the remote control but not received by the amplifier. In
this case, move closer to the amplifier until the LED is
green and radio connection is re-established.
• Red flashing: the remote control battery is low. When
the LED is in this state, the battery has 30 minutes of life
before the remote control will turn off.
• Yellow flashing or steady : The remote control is
signaling the amplifier successfully but the battery power
is low.
Programming Mode
The hand-held remote control can be put in programming
mode to change the radio power output, the radio channel,
and the range finder function.When in programming mode,
the remote control flashes a fast red-green sequence every
eight seconds.
Battery Replacement
The PP3 9V battery in the remote control can be replaced
with either alkaline or lithium-ion rechargeable types.
Typically, the battery lasts more than 60 hours under normal
conditions. For instructions on replacing the battery, see the
"First Use" chapter in this manual.